Connecting The Appliance; Switching On The Appliance - Bosch KGS SERIES Operating Instructions Manual

Connecting the
appliance
After installing the appliance, wait at least
½ hour before switching on the appliance.
During transportation the oil in the
compressor may have flowed into the
refrigeration system.
Before switching on the appliance for the
first time, clean the interior (see Cleaning).
The socket should be freely accessible.
Connect the appliance to
220-240 V/50 Hz alternating current
via a correctly installed earthed socket.
The socket must be fused with a 10 A to
16 A fuse.
If the appliance is to be operated
in a non European country, check
on the rating plate whether the
indicated voltage and current type
correspond to the values of your
mains supply. The rating plate
is situated in the bottom left hand side
of the appliance. The mains
connection cable may be replaced by
an electrician only.
Warning!
!
Never connect the appliance
to electronic energy saver plugs or to
power inverters which convert the
direct current to 230 V alternating
current (e.g. solar equipment, power
supplies on ships).
Downloaded from Fridge-Manual.com Manuals
Switching on
the appliance
The refrigerator and freezer compart
ments operate independently of each
other.
Freezer compartment
Press the On/Off button Fig. 2/1.
Warning signal is emitted. To stop the
warning signal, press the Alarm button.
The Alarm button remains lit until the set
temperature has been reached.
Fridge
Press the On/Off button Fig. 2/9.
The appliance starts refrigerating.
Interior light in refrigerator compartment
is switched on when the door is open.
Selecting the temperature
Keep pressing the temperature selection
button for the refrigerator compartment
or freezer compartment until the required
temperature lamp is lit.
The appliance left the factory with the
following standard setting:
Freezer compartment:
Refrigerator compartment:
We recommend a temperature selection
of +4 °C.
Perishable food should not be stored
warmer than +4 °C.
en
-18 °C
+4 °C
9