Weigh Babies/Toddlers (2 In 1); Continuous Display Of Measured Result (Hold) - Seca 284 User Manual

Weigh babies/toddlers
Continuous display of
measured
result (HOLD)
86 •
You can use the 2 in 1 function to weigh babies and
(2 in 1) toddlers. Here the child is held by an adult during
weighing. Proceed as follows.
1. Ensure that there is no load on the scales.
2. Press the Start key
display.
3. Ask the adult to step onto the scales.
The adult's weight is displayed.
4. Press the 2 in 1 key.
The weight is saved.
0. 0 0
in the display.
5. Ask the adult to step onto the scales with the child.
The child's weight is displayed.
The
"NET" are displayed.
6. To disable the 2 in 1 function, press the 2 in 1 key
or switch off the scales.
If you activate the HOLD function, the weight value
continues to be displayed after the load has been
removed. This allows you to attend to the patient
before noting down the weight.
1. Ensure that there is no load on the scales.
2. Press the Start key
display.
, the symbol and the NET message appear
ATTENTION!
Incorrect measurement due to change in initial
weight
If the child is weighed with a different initial
weight, the child's weight cannot be calculated
correctly.
– Ensure that the child is always weighed with
the adult used to determine the initial weight.
– Ensure that the weight of this adult does not
change, e.g. as a result of taking off a
garment.
symbol and the messages "HOLD" and
of the multifunctional
of the multifunctional