Service; Electrical Connection; Proportional Valve Adjustment; How To Remove Range For Cleaning And Servicing - Magic Chef cgr3760adh Owner's Manual

ELECTRICAL CONNECTION

Appliances which require electrical power are
equipped with a three-prong grounding plug which
must be plugged directly into a properly grounded
three-hole 120 volt electrical outlet.
Always disconnect power to appliance before servicing.
The three-prong grounding plug offers protection against
shock hazards. DO NOT CUT OR REMOVE THE THIRD
GROUNDING PRONG FROM THE POWER CORD
PLUG.
If an ungrounded, two-hole or other type electrical outlet is
encountered, it is the personal responsibility of the
appliance owner to have the outlet replaced with a
properly grounded three-hole electrical outlet.

PROPORTIONAL VALVE ADJUSTMENT

The LOW setting should produce a stable flame when
turning the knob from HI to LO. The flame should be 1/8
inch or lower and must be stable on all ports on LOW
setting.
To adjust: Operate burner on HI for about 5 minutes to
preheat burner cap. Turn knob back to LO; remove knob,
and insert a small screwdriver into the center of the valve
stem. Adjust flame size by turning adjustment screw in
either direction.
Flame must be of sufficient size to be stable on all burner
ports. If flame adjustment is needed, adjust ONLY on the
LO setting. Never adjust flame size on a higher setting.
NOTE: All gas adjustments should be done by a qualified
servicer only.
SERVICE INFORMATION
HOW TO REMOVE RANGE FOR CLEANING
AND SERVICING
Follow these procedures to remove appliance for cleaning
or servicing:
1. Shut-off gas supply to appliance.
2. Disconnect electrical supply to appliance, if equipped.
3. Disconnect gas supply tubing to appliance.
4. Slide range forward to disengage range from the
anti-tip bracket. (See Installation Instructions for
location of bracket.)
5. Reverse procedure to reinstall. If gas line has been
disconnected, check for gas leaks after reconnection. A
qualified servicer should disconnect and reconnect the
gas supply. (See Installation Instructions for gas leak
test method.)
NOTE: A qualified servicer should disconnect and
reconnect the gas supply.
To prevent range from accidently tipping, range must be
secured to the floor by sliding rear leveling leg into an
anti-tip bracket supplied with the range.
WARNING: Possible risks may result from abnormal
usage, including excessive loading of the oven door
and of the risk of tip over, should the appliance not be
reinstalled according to the installation instructions.

EXPLANATION OF FAULT CODES

If a fault code appears in the display and continuous
beeps sound, press the CANCEL pad. Then, reprogram
the cooking operation. If the fault code reappears in the
display, call an authorized servicer. Do not use the oven
until the appliance has been serviced.
NOTE: If the oven is heavily soiled, excessive smoke and
flaring may result in a fault code during a self-clean cycle.
If this occurs, press the CANCEL pad and allow the oven
to cool for an hour.
28