Sub-Zero UC-15I Installation Manual page 9

IN S TA L L AT I O N
Installation
R EVE R S E D O O R S WI N G
The door hinges are designed to be placed on either the
right or left side of the ice machine. The unit is shipped with
the door hinged on the right. Moving the hinges to the left in
pre-drilled holes, allows for a left-hand door swing.
To reverse door swing:
Detach the hinges from the ice machine by removing two
1
screws per hinge, then remove the door. Remove the
shim located between the cabinet and bottom hinge, this
shim will transfer to the left side bottom hinge.
Detach the hinges from the door by removing two
2
screws per hinge.
Detach the right-hand upper trim (shaded area) from the
3
door by removing two screws. Refer to the illustration
below. Replace it with the left-hand upper trim.
Transfer the hinges to the left side of the door and
4
reinstall. The upper hinge will now be in the lower hinge
position and the lower hinge in the upper hinge position.
HINGE
SCREWS
Remove door.
UPPER HINGE
TRIM (RH)
HINGE
Detach hinges and trim.
Remove the top cover of the ice machine by removing
5
two screws at the top rear of the unit.
Remove four screws from the front top rail, then pivot
6
the top rail end for end to expose the two left-hand top
hinge mounting holes and reinstall. Refer to the illustra-
tion below.
Remove two screws from the lower edge of the bottom
7
trim plate and slide it to the right to cover the right hinge
mounting holes. Refer to the illustration below. The left
hinge mounting holes will now be exposed.
Reinstall the shim removed in step 1, between the
8
cabinet and the left side bottom hinge. Reinstall the door
by mounting the hinges using the left hinge mounting
holes. Verify operation of door.
TOP RAIL
SCREWS
Front top rail.
TRIM PLATE
SCREWS
Bottom trim plate.
|
subzero.com 9