Completion - Sub-Zero UC-15I Installation Manual

IN S TA L L AT I O N

Completion

KI C K P L AT E I NS TA L L AT I O N
Install the kickplate using two screws provided. Refer to
the illustration below. The kickplate must be removable
for service. The floor cannot interfere with removal. Do not
cover the louvered section of the kickplate.
90 ° DO O R S T O P
Door stop pins provided with the ice machine will limit the
door swing to 90°.
To install, open the door to approximately 80°. Insert one
stop pin into the top door hinge (pin enters from the bottom)
and the other stop pin into the bottom door hinge (pin
enters from the top). Refer to the illustration below. Check
for proper operation.
DOOR STOP PIN
90° door stop.
Sub-Zero, Sub-Zero & Design, Dual Refrigeration, The Living Kitchen, Great American Kitchens The Fine Art of Kitchen Design, and Ingredients are registered trademarks and service
marks of Sub-Zero, Inc. Wolf, Wolf & Design, Wolf Gourmet, W & Design and the color red as applied to knobs are registered trademarks and service marks of Wolf Appliance, Inc.
All other trademarks or registered trademarks are property of their respective owners in the United States and other countries.
H IN GE C O VER S
Install hinge covers once installation of the ice machine is
complete and door stop pins have been installed (if appli-
cable). The knock-out in the hinge cover must be removed
if the 90° door stop is used.
Verify hinges are free of dirt or grease before applying
covers. To install, remove paper backing and apply hinge
covers to each hinge. Attach the magnetic center covers.
Refer to the illustration below.
WARNING
Follow all city and state laws when storing, recycling or
discarding unused refrigerators and freezers.
KNOCK-OUT
Hinge covers.
|
subzero.com 11