Sub-Zero UC-15I Installation Manual page 8

IN S TA L L AT I O N
Installation
V E R IF Y I CE P RO D UCT I O N
Press 'POWER' to turn the ice machine on.
1
Add one gallon of cold water to the ice bin. Verify
(3.8 L)
2
the water completely drains from the ice bin and there
are no leaks. If the water has not drained within 60 sec-
onds, there may be a kink in the drain tube or incorrect
drain installation.
Press 'CLEAN'. Wait three minutes until the CLEAN light
3
flashes, then add 1 tablespoon
machine sanitizer directly into the spray area. Refer to
the illustration below. Use only the sanitizer made for the
Sub-Zero ice machine available at subzerowolfstore.com.
For questions, contact Sub-Zero customer care at
800-222-7820.
WATER
SHUTTERS
Water shutters location.
|
8 Sub-Zero Customer Care 800.222.7820
of undiluted ice
(15 ml)
A 10-minute sanitizing cycle begins, followed by eight
4
rinse cycles. When the process is complete, the CLEAN
light will no longer be illuminated. The entire cycle takes
approximately 30 minutes.
At initial start-up, the ice machine will need approxi-
5
mately 30 minutes to freeze ice cubes and up to five
minutes to harvest. Verify completion of the first cycle ice
production to confirm proper installation.