Service & Repair Information - Jiffy 4G Operating Manual/Parts Manual

EZ CONNECT COLLAR™ - This item is used to connect your Jiffy®
power head to the drill assembly and should be checked before each
use for proper installation and connection. Improper installation or
positioning of the EZ Connect Collar™ could cause the loss of your
drill assembly down the hole if the connection is not properly
installed
AIR FILTER – The engine has an air cleaner which helps prevent
premature engine wear and failure. Never run an engine without a
complete, clean air filter properly installed. Clean or replace air filter
as needed.
REPLACEMENT TEETH – Improper or difficult cutting may be due
to dull or damaged drill teeth or drill point. Maintain sharp blade
teeth and point. Preserve the original factory cutting angles when
sharpening your drill. File blade teeth and use a disk sander to
sharpen the point. Only genuine Jiffy® blade teeth are to be used.
END OF SEASON CARE
1. Lubricate throttle cable and carburetor throttle shaft
2. Check the entire ice drill for any loose hardware. Tighten
hardware, if necessary.
3. Engine oil should be changed once a year.
recommended to do this at the end of the season.
4. Store power head with the power head in the upright
(operating) position or laid down with the spark plug up.
5. Check spark plug.
0.018".
6. It is recommended to drain all fuel out of the fuel tank.
Then start the engine and run it until it stops.
SERVICE & REPAIR INFORMATION
BLADE TEETH REPLACEMENT
replacing blade teeth, the beveled edge of teeth and the head of the
caps crews should face the ice. The stamped part number on the
teeth should face away from the ice, as shown in the diagram. Use
two 7/16" wrenches to remove the cap screws.
blades, finger tighten all fasteners, then fully tighten with wrenches.
CAUTION – THE BLADE TEETH ARE SHARP AND
SHOULD BE HANDLED CAREFULLY TO AVOID FLESH
CUTS OR INJURY.
Replace if necessary and gap at
When
INSTRUCTIONS –
When attaching
Instructions:
1. Please send the following information:
Send sales receipt, UPC label ( No Photocopies), three Stealth
2.
STX™ Blades or the Ripper™ blade and $17.95 in US dollars
for return Shipping and Handling to:
It is
Jiffy® Blade Warranty –
● One Time Sharpening or Replacement
● Expires Two Years after Date of Purchase
Please Allow 3 Weeks for Delivery!
ENGINE SPEED – NEVER TAMPER WITH ENGINE SPEED
CONTROL SYSTEM, OVERSPEEDING THE ENGINE CAN BE
DANGEROUS AND MAY CAUSE PERSONAL INJURY OR DAMGE
TO UNIT. TAMPERING WITH ENGINE SPEED CONTROL SYSTEM
WILL VOID ENGINE WARRANTY.
For engine adjustments, repairs or warranty service not covered in this
manual, visit our web site at www.jiffyonice.com,visit one of our authorized
Jiffy service, or for Canadian customers, please call 1-800-861-9559. When
requesting warranty service, Jiffy® ice drill proof of purchase (sales receipt)
establishes the date of sale and the start of the warranty period.
-5-
Blade Warranty
Name,
Address,
City, State/Province, Zip/Postal Code,
Country,
Telephone Number,
Email Address,
Date of Purchase
Jiffy® Serial Number
Feldmann Engineering & Mfg. Co. Inc.
520 Forest Avenue
Sheboygan Falls, WI 53085 USA