Advertisement
2.
Remove and inspect spark plug for carbon build up and
set gap at .030".
3.
Replace spark plug if electrodes are pitted, burned, or
porcelain is cracked. For replacement use: Autolite 2976,
Champion RCJ-6Y, or equivalent.
4.
Check electrode gap with wire feeler gauge and set gap at
.030 if necessary.
5.
Install spark plug in engine and tighten to 15 foot pounds
torque or tighten securely.
REPLACEMENT TEETH – Improper cutting may be due to dull or
damaged drill teeth or drill point. Maintain sharp blade teeth and
point. Preserve the original factory cutting angles when sharpening
your drill. File blade teeth and use a disk sander to sharpen the
point. For professional service see your Jiffy service center. Only
genuine Jiffy blade teeth are to be used.
AIR CLEANER – Never run an engine without the complete air
cleaner installed. For maintenance of the air cleaner see air cleaner
maintenance section in the Tecumseh engine manual.
BLADE
TEETH
REPLACEMENT
replacing blade teeth, the beveled edge of teeth and the head of the
capscrews should face the ice. The stamped part number on the
teeth should face away from the ice, as shown in the diagram. Use
two 7/16" wrenches to remove the capscrews and to retighten after
replacement. CAUTION – THE BLADE TEETH ARE SHARP AND
SHOULD BE HANDLED CAREFULLY TO AVOID FLESH CUTS
OR INJURY.
CARBURETOR – For carburetor adjustment see your nearest
AUTHORIZED TECUMSEH SERVICE OUTLET.
ENGINE SPEED – NEVER TAMPER WITH ENGINE GOVERNOR,
OVERSPEEDING THE ENGINE CAN BE DANGEROUS AND MAY
CAUSE PERSONAL INJURY OR DAMGE TO UNIT.
TAMPERING WITH ENGINE GOVERNOR WILL VOID ENGINE
WARRANTY.
For engine adjustment or repairs not covered in this section see the
Service & Repair Information section below.
IF ENGINE IS NOT TO BE USED FOR 30 DAYS OR MORE,
PREPARE AS FOLLOWS:
FUEL SYSTEM – Remove FUEL from CARBURETOR and FUEL
TANK to prevent formation of gum deposits. DRAIN FUEL FROM
COOL ENGINE INTO AN APPROVED CONTAINER OUTDOORS,
AWAY FROM OPEN FLAME. DO NOT SMOKE. Then start and
run engine until fuel remaining in tank is consumed and engine
stops.
INSTRUCTIONS
–
When
NOTE: If "gasohol" has been used, read special instructions found in
the Tecumseh engine manual or contact a Tecumseh Service Center.
SERVICE & REPAIR INFORMATION
For engine adjustments, repairs or warranty service not covered in this
manual, contact your nearest AUTHORIZED TECUMSEH SERVICE
OUTLET.
They are listed in your telephone book yellow pages under
"Engines, Gasoline". If you cannot find an Authorized Tecumseh Service
Outlet near you, call 1-800-558-5402
you.
When requesting warranty service, Jiffy ice drill proof of purchase
establishes the date of sale and the start of the warranty period.
For non-engine related adjustments, repairs or warranty service contact your
nearest Authorized Jiffy Service Center listed in the Jiffy Service Directory or
call (920) 467-6167 for locations near you, or visit our web site at
www.jiffyonice.com.
IMPORTANT INFORMATION
For new, detailed starting instructions
and other important information, read
the Tecumseh Operator's Manual
#181-1274-14 for TM049XA engines
to locate the Tecumseh outlets nearest
5
Hide quick links:
Advertisement
