Assembling The Stand - Epson STYLUS PRO 10600 Assembly And Set-Up Manual

For United Kingdom Users
Use of options
EPSON (UK) Limited shall not be liable against
any damages or problems arising from the use of
any options or consumable products other than
those designated as Original EPSON Products or
EPSON Approved Products by EPSON (UK)
Limited.
Safety Information
w
Warning:
This appliance must be earthed. Refer to rating
plate for voltage and check that the appliance
voltage corresponds to the supply voltage.
Important:
The wires in the mains lead fitted to this appliance are
coloured in accordance with the following code:
Green and yellow – Earth
Blue – Neutral
Brown – Live
If you have to fit a plug:
As the colours of the mains lead of this appliance
may not match coloured markings used to
identify the terminals in a plug, please proceed as
follows:
The green and yellow wire must be connected to
the terminal in the plug which is marked with the
letter E or earth symbol (G).
The blue wire must be connected to the terminal
in the plug marked with the letter N.
The brown wire must be connected to the terminal
in the plug marked with the letter L.
If damage occurs to the plug, replace the cord set
or consult a qualified electrician.
Replace fuses only with a fuse of the correct size
and rating.
2
Warning, Cautions, and Notes
w
Warnings must be followed carefully to avoid
bodily injury.
c
Cautions must be observed to avoid damage to
your equipment.
Notes contain important information and useful tips
on the operation of your printer.

Assembling the Stand

c
Caution:
Have two people working on either side to
assemble the stand.
1. Hold base upright left (A) and a horizontal
strut (C) as shown. Then fix the strut to the
stand using the two hex socket head bolts (I)
with the hex wrench (H).
I
Note:
An instruction sticker about the setting paper
basket is attached to the side of horizontal strut.
2. Referring the step 1, fix the other strut to the
base upright right (B).
This completes assembly of the stand. Before
attaching the paper basket, mount the printer
on the stand.