Filters - Hoover uh70608 Owner's Manual

Howto Empty
4.3 Press dirt cup
release button (A) and
pivot cup out.
4.4 Hold dirt cup over
trash receptacle, push
dirt cup door release
lever (B) to open dirt
cup door (C).
Close dirt cup door (C). D
Press firmly to secure
at front (D).
4.5 Place bottom of dirt cup into vacuum body first. Pivot dirt cup into vacuum
body and press firmly until it locks into place.
FILTERS: Whento Clean
To maintain optimal performance, filters should
be cleaned at least every two months under
normal use.
RinsableFilter:Howto Clean
Remove dirt cup as described in Fig. 4.3.
4.6 Pull up on dirt cup latch to open.
4.7 Pull on filter by 1he pocket to remove rinsable filter.
Hold tilter under running water for at least two
minutes to remove dirt and debris. Squeeze filter
twice while underwater. Remove from water and
squeeze a final time to remove excess water.
• IMPORTANT •
Allow filter to dry completely before replacing.
Dry filter on edge so air circulates on both sides
of fiJter. This may take up to 48 hours.
Replace filter with pocket and graphics facing up.
Close lid securely by pushing until it c]icks.
Replace dirt cup as desc_bed in Fig 4.5.
,& WARNING
To reduce the risk of personal injury - Unplug
before cleaning or servicing. Do not use
vacuum without dirt cup or filters in place.
m
Filter MadeWithHEPA Media:HowtoClean
4.8 With fingers in slots, pull filter frame (A) ^""
WARNING ^'-
straight
out. Hold filter over a trash receptacle To reduce the risk of personal injury - Unplug
and tap out dirt and debris, before cleaning or servicing. Do not use
vacuum without dirt cup or filters in place.
Slide back into position on vacuum.
• IMPORTANT ° ]
DO NOT RINSE OR WASH THE FILTER MADE WITH HEPA MEDIA.
11 Actual model may vary from images shown.