Changing Batteries - Vermeiren RAPIDO Instruction Manual

•
Pull the fixing knobs out on both sides and press the locks upward on both sides.
•
Pull the first battery out by grasping the carrying handle.
•
The second battery can be pulled forward by means of the attached loop until you can reach the
carrying handle for removing it.
Batteries are replaced in the reverse sequence.
•
Place the battery container in the guide and push it in until the plug engages the battery socket.
•
Do the same with the second battery until the connections of both batteries engage each other.
•
Now press the latches downwards until they are visible above the groove of the battery case.
•
If the securing knobs do not engage automatically, turn them until both knobs are locked in
position.
Check objects and body parts to avoid crushing.
The batteries must be pushed in the correct sequence (they can only be installed in one way –
see the circuit diagram).
After putting the batteries in place, check that both securing knobs are locked – only then can
the wheelchair be used.

CHANGING BATTERIES

This should only be done by technicians.
Make sure that no tools or other conducting objects might short-circuit a battery by contact
with the poles, since the high current could cause injuries.
Activities involving the batteries and the electronics should not be undertaken in a humid
environment.
Only original spare parts and batteries supplied by the manufacturer should be used.
Take note of the circuit diagram (batteries must not be connected differently).
The manufacturer does not accept any liability in the case of damage or injury caused by
improper use or by employing batteries and spare parts not supplied by the manufacturer.
OUTPUT
24 V
-
Black
-
+
Figure – circuit diagram batteries
+
Battery I
Red
+
-
Brown
+
-
8
RAPIDO
2012-07
-
Red
+
Battery II
Brown