Table of Contents
Advertisement
process for each port that you want to enable for that Key. The appropriate
LED (1–8) on the Modem Router Switch will light with each selection.
6. After you have completed programming all the Keys, disconnect them and
select the Run Mode on the Modem Router Switch (#0, Green LED).
If you want to make sure that the proper code is loaded, you can read the Keys by
performing only Steps 1 and 2.
3.3.3 P
ROGRAMMING THE
You only need the password for Touch-tone routing. It requires four characters.
The factory-default password is 0000. To change the password to 1234, for
example, follow these steps:
1. Connect a touch-tone telephone to the PROG 1 jack and go off-hook.
2. Set the function switch to Position 8 (enable TT) and press Enter.
3. Enter #1234 (don't forget the # sign at the beginning). You will hear two
beeps.
4. Enter #1234 again. You will hear four beeps, if successful. (You will hear one
long beep if unsuccessful.)
5. The password is now changed to 1234. Reset the Program Mode Switch to
Position 0, the Run position.
To reset the password to its factory default, place the program switch
on #4 and hold the Enter button in while powering on the Modem Router
Switch.
3.4 Accessing the Router Switch
3.4.1 T
-
OUCH
TONE
To dial into the modem router, dial the telephone number and wait a few seconds
for the router to answer. Once it answers, send a #, the Password, and the desired
port number (1–8). We recommend sending the optional AC power command
even if you're not using a power strip. The router will ring the port. When the
equipment connected to the port answers, the call connects.
T
-
OUCH
TONE
A touch-tone telephone set is required.
M
ODE
P
ASSWORD
NOTE
NOTE
CHAPTER 3: Operation
19
Advertisement
Table of Contents
