Table of Contents
Advertisement
Table 2-2 (continued). Rear-panel components and their functions.
Component
❻
Rotary Program Mode Switch A rotary Program Mode Switch is located in the
0
1
2
3
4
5
6
7
round opening. It is labeled 0–7 and programs
the Router Switch as well as the Security
Selection Keys, if used. The switch positions'
functions are explained below. The
corresponding LED is also referenced.
0=Run Mode (LED C)
NOTE: This is the only mode in which calls will
be processed.
1=Key Program Mode. Allows the Security
Selection Keys to be programmed (LEDs 1–8).
2= Selects Routing Method. Touch-tone,
Security Key, or Key & Touch toggle (LED 9).
3=Enable/Disable (toggle) Outbound Calls (LED
12).
4=Shows the last command state of the AC
power strips connected to any of the ports.
5=Enable/Disable (toggle) Route Unauthorized
Calls to Port 1 (LED 11).
6=Enable Touch-tone Password programming.
(LED 9).
7=Enable or Disable (toggle) outbound calls on
Telco Port 2 (LED 10).
CHAPTER 2: Overview
Function
15
Advertisement
Table of Contents
