Hdmi Monitor - Yamaha AVENTAGE RX-A1060 Owner's Manual

⬛

HDMI Monitor

Displays information about the TVs connected to the HDMI OUT jacks.
Use the Cursor keys (q/w) to switch between "OUT1" and "OUT2".
Interface TV interface
Video Resolution Resolutions supported by the TV
⬛
Network
Displays the network information on the unit.
(When using wired or wireless [Wi-Fi] network connection)
IP Address IP address
Subnet Mask Subnet mask
Default Gateway The IP address of the default gateway
DNS Server (P) The IP address of the primary DNS server
DNS Server (S) The IP address of the secondary DNS server
MAC Address (Ethernet)
MAC address
MAC Address (Wi-Fi)
vTuner ID vTuner ID
Network Name Network name (the unit's name on the network) (p.122)
MusicCast Network The status of the MusicCast network connection
Wired/Wireless The status of the wired or wireless connection
(When using wireless [Wi-Fi] network connection)
SSID
The SSID of the wireless network
(When using Wireless Direct)
SSID The SSID of the wireless network
Security Security method
Security Key Security key
IP Address IP address
Subnet Mask Subnet mask
MAC Address (Wi-Fi) MAC address
MusicCast Network The status of the MusicCast network connection
Network Connection "Wireless Direct" indication
⬛
System
Displays the system information on the unit.
Remote ID The unit's remote control ID setting (p.132)
TV Format The unit's video signal type (p.132)
Speaker Impedance The speaker impedance setting of the unit (p.131)
(Asia and General models only)
Tuner Freq. Step
The FM/AM tuning frequency setting of the unit (p.132)
System ID System ID number
Firmware Version The version of firmware installed on the unit
X
If the unit detects a newer firmware over the network,
"Information" and "System" icons, and the corresponding message will be displayed in this screen. You can
update the unit's firmware by pressing ENTER in this screen and following the procedure in "Updating the unit's
firmware via the network" (p.135).
⬛
Multi Zone
Displays information about Zone2.
Input The input source selected for Zone2
Volume The volume for Zone2
130
En
(mail icon) appears at the upper right of the