Connecting The Hotsync Cradle - Palm m500 Series Handbook

HotSync operations" in Chapter 5 "for details, or refer to Getting
Started with Palm™ m500 Series Handhelds.
(If upgrading) Rename your old handheld. To prevent unexpected
results during HotSync operations, each handheld must have a
unique name. We recommend that you perform a hard reset on
your old handheld. See "Performing a hard reset" in Appendix A
for details.

Connecting the HotSync cradle

Important: The HotSync cradle supplied with your handheld fits a
USB connector. If your computer does not have a USB
port, or if you are using Windows 95, Windows NT, or an
older Macintosh, you can order a serial cradle and a 25-
pin serial adapter, if necessary, from
www.palm.com
accompanies the serial cradle before attempting to
complete the installation tasks.
1. Shut down and turn off your computer.
2. Plug the USB connector into a USB port on your computer.
3. Connect the power cord that attaches to the back of the cradle's
USB port connector to the AC adapter cord.
Page 10
. Follow the documentation that
Introduction to Your Handheld
http://