Connecting The Cooktop To The Mains Power Supply - Fisher & Paykel CI302CTB1 Installation Instructions Manual

IMPORTANT!
This cooktop must be connected to the mains power supply only by a suitably qualified
● ●
person.
To connect the cooktop to the mains power supply, do not use adapters, reducers, or
● ●
branching devices, as they can cause overheating and fire.
The power supply cable must not touch any hot parts and must be positioned so that its
● ●
temperature will not exceed 75 C at any point.
o
Check with an electrician whether the domestic wiring system is suitable without alterations.
Any alterations must only be made by a qualified electrician.
Before connecting the cooktop to the mains power supply check that:
The domestic wiring system is suitable for the power drawn by the cooktop.
● ●
The voltage corresponds to the value given in the rating plate
● ●
The power supply cable sections can withstand the load specified on the rating plate.
● ●
Power supply
CI302CTB 3700W@ 220-240V 1N ~ 16A*
CI604CTB 7400W @ 220-240V 1N - 32A
CI704CTB 7400W @ 220-240V 1N - 32A
CI804CTB 7400W @ 220-240V 1N ~ 32A
CI904CTB 7400W @ 220-240V 1N - 32A
*The CI302CTB comes supplied with a cable. This must be wired into a suitably rated plug,
permanent connection outlet or power isolator.
!1 FIT CLAMPING BRACKETS BASED ON THE
BENCHTOP THICKNESS
No. of brackets and slot positions depends on model
view from below
12-40mm
12-40mm
!0

CONNECTING THE COOKTOP TO THE MAINS POWER SUPPLY

40mm +
Fit a minimum of
2 brackets on opposing sides
40mm +
Brown
Unclip
(Live)
and lift up
Blue
(Neutral)
L
CI604CTB, CI704CTB, CI804CTB, CI904CTB
Single-phase connection
220-240V~
2 4
1 3
N L
!2 SECURE TO BENCHTOP
Secure on at least 2
opposing sides
Repeat on all the other brackets
E
Ensure cable
clamp is tightened
with screw
(you may have
to remove the
Green
screw rst
& Yellow
before tting
(Earth)
the clamp)
5
PE
9