Pacific Upright Vacuum Cleaner Operating Instructions Manual page 3

Step 2 Attach cord
3
"UP"
D
Note: The small red tab (E) above the ON/OFF switch (F) is for shipping
purposes only and may fall off during assembly. If it does not fall off, the tab
will be removed during the final steps of assembly.
Turn handle over. Insert large rectangular end of cord into pocket in bottom of
handle, with side marked "UP" visible.
Make sure rectangular end is pushed into handle as far as possible.
Slide cord protector (G) toward upper handle (B).
5
H
J
With arrow on cord protector (H)
pointing toward arrow on upper han-
dle (I), press groove (J) in
cord protector into slot (K) in upper
handle.
Step 3 Attach cloth outer bag
7
M
L
Note location of tapered rails (L) on
back of outer bag base (M) and on
front of lower handle (C).
G
F
C
6
I
UP
K
Pull cord tight.
Press cord into place at each of the three notches indicated and note correct
positioning of (G).
Do not plug cleaner in until assembly is totally complete.
8
M
C
C
Slide rails on outer bag (M) onto
rails on lower handle (C) until outer
bag base snaps past the lock tab
(N).
B
E
N
4
H
Rotate cord protector (G) on cord
until you see its arrow (H).
G
9
O
M
N
Make sure hole in outer bag base
aligns with hole in handle (O).
Be sure that power cord is pulled
tight and pressed into each of the
three notches (Fig. 6) before com-
pleting the following steps.
Continued
G
3