Maintenance; Engine Adjustments; Slip Rings; Engine Maintenance Parts - Lincoln Electric RANGER 10,000 PLUS Operator's Manual

D-3

ENGINE ADJUSTMENTS

OVERSPEED IS HAZARDOUS
The maximum allowable high idle speed for this
machine is 3750 RPM, no load. Do NOT tamper
with governor components or setting or make any
other adjustments to increase the maximum
speed. Severe personal injury and damage to the
machine can result if operated at speeds above
maximum.
------------------------------------------------------------------------
Adjustments to the engine are to be made only by a
Lincoln Service Center or an authorized Field Service
Shop.

SLIP RINGS

A slight amount of darkening and wear of the slip rings
and brushes is normal. Brushes should be inspected
when a general overhaul is necessary.If brushes are
to be replaced, clean slip rings with a fine emery
paper.
Do not attempt to polish slip rings while engine is
running.
------------------------------------------------------------------------
Oil Filter
Air Filter
Element
Air Filter
Pre-Cleaner
Fuel Filter
Spark Plugs
(Resistor
Type)
Downloaded from www.Manualslib.com

MAINTENANCE

WARNING
CAUTION

ENGINE MAINTENANCE PARTS

KOHLER C23S
KOHLER 1205001
FRAM PH8172*
KOHLER 4708303
FRAM CA79
KOHLER 2408302
KOHLER 2405010
CHAMPION RC12YC
(.030" GAP)
* Oil capacity increases from 2.0 Qts. to 2.1 Qts. when using this filter.
RANGER 10,000 PLUS AND RANGER 10,000
manuals search engine
GASES FROM BATTERY can explode.
• Keep sparks, flame and cigarettes away from battery.
To prevent EXPLOSION when:
• INSTALLING A NEW BATTERY - disconnect negative
cable from old battery first and connect to new battery
last.
• CONNECTING A BATTERY CHARGER - Remove bat-
tery from welder by disconnecting negative cable first,
then positive cable and battery clamp. When rein-
stalling, connect negative cable last. Keep well venti-
lated.
• USING A BOOSTER - connect positive lead to battery
first then connect negative lead to engine foot.
BATTERY ACID CAN BURN EYES AND SKIN.
• Wear gloves and eye protection and be careful when
working near battery. Follow instructions printed on
battery.
BATTERY
1. When replacing, jumping, or otherwise connecting
the battery to the battery cables, the proper
polarity must be observed. Failure to observe
the proper polarity could result in damage to the
charging circuit. The positive (+) battery cable
has a red terminal cover.
2. If the battery requires charging from an external
charger, disconnect the negative battery cable
first and then the positive battery cable before
attaching the charger leads. Failure to do so
can result in damage to the internal charger
components. When reconnecting the cables,
connect the positive cable first and the negative
cable last.
HARDWARE
Both English and Metric fasteners are used in this
welder.
SUBARU ROBIN EH65
SUBARU ROBIN
248-65801-00, FRAM PH4967
SUBARU ROBIN
263-32610-A1
N/A
SUBARU ROBIN
011-00600-20
SUBARU ROBIN
X65-01407-30
NGK-BPR4EY
WARNING
HONDA GX620KI
HONDA
15410-ZJ4-999A
HONDA
17210-ZJ1-841
HONDA
17218-ZJ1-840
HONDA
16910-ZE8-015
CHAMPION -J16CR-U
NGK-ZGR5A
030in, (76 mm) Gap
D-3