Connect The Power Cord - Brother dcp 9020 cdn Quick Setup Manual

d
Load paper in the tray and make sure:
 The paper is below the maximum paper
mark (bbb) a. Overfilling the paper tray will
cause paper jams.
 The side to be printed on is face down.
 The paper guides touch the sides of the
paper so it will feed correctly.
e
Put the paper tray firmly back in the machine.
Make sure it is completely inserted into the
machine.
f
Lift the support flap a to prevent paper from
sliding off the face-down output tray.
For information about recommended paper:
uu Basic User's Guide: Recommended
paper and print media.
4

Connect the power cord

IMPORTANT
DO NOT connect the interface cable
yet.
a
Connect the AC power cord to the machine and
then plug it into an electrical socket.
b
Press on the control panel.
IMPORTANT
DO NOT touch the Touchscreen immediately
after plugging in the power cord or turning the
machine on. Doing this may cause an error.
5
Choose your language
(if needed)
a
Press .
b
Press All Settings.
c
Swipe up or down, or press a or b to display
Initial Setup.
Press Initial Setup.
d
Press Local Language.
e
Press your language.
f
Press .
5