Mode Selection - Sharp VC-H900X Operation Manual

Mode Selection

You can set the basic functions listed in the table below on the MODE selection screen
PREPARATION
*Turn on your TV and select the video channel. Turn on the VCR. (See page 5, item 3.)
[REPEAT]
(For details, see Colour Mode on page
A U T O U s u a l l y s e l e c t A U T O m o d e
PAL
or
NTSC S t r i c t N T S C c o l o u r m o d e
(For details, see NTSC AV Recording on page 25.)
NTSC 3.58 When using NTSC 3.58 TV system format. (Input signal:
NTSC 4.43
PAL TV ..,,,.......,., When using PAL TV system format. (Input signal: NTSC 4.43)
(For details, see Blue Back on page 22.)
AUTO Usually select AUTO.
OFF ..,....... Select OFF if the screen turns blue due to weak TV signal reception, or
(For details, see Auto Repeat on page 37.)
(For details, see Intelligent Timer Recording (JUST
REC) on page 32.)
(For details, see Audio Dubbing
S t r i c t P A L c o l o u r m o d e
NTSC 3.58)
When using NTSC 4.43 TV system format. (Input srgnal:
NTSC 4.43)
blue screen will appear when your VCR receives no TV signal or an
A
unrecorded tape is played back.
playback of a poorly recorded tape.
20.)
on page 32,)
17