Simple Recording Timer - Sharp VC-H900X Operation Manual

Simple Recording Timer

There are two ways to use this Simple Recordinq Timer for 1
your convenience:
Press STOP to terminate recording
l
.
*After the Simple Recording Timer
ending time. And turn to the POWER STANDBY mode.
To clear the Simple Recording Timer setting during setting of "Delayed Recording", press CLEAR on the remote control. To
l
after setting, turn on the power, press OTIME to select Simple Recording Timer mode, and then while the 0START
time is flashing, press CLEAR
*The Simple Recording Timer cannot be set if the timer has been preset ("Q" indicator on the VCR display
case, cancel the timer standby mode with TIMER ON/OFF,
Recording Timer.
Select the SP (Standard Play) or LP (Long Play) recording speed with TAPE SPEED on the remote control ("SP" or "LP"
l
light up on the VCR display). SP (Standard Play) gives the best picture quality LP (Long Play) gives the largest recording
time.
The stop time for delayed recording must be set wlthin 10 seconds of setting the start time, otherwise start time must be set
l
again
2 6
l
l
CHANNEL A/V (CH A./V).
Each press of REC Increases the stop time by IO minutes.
l
CHANNEL A/V (CH A/V).
. . . . . .
(Ex.: Channel position: 2)
Each press of
l
Each press of REC increases the stop time by IO minutes.
l
set, the channel posltion cannot be changed
IS
Immediate recordinq:
Convenient when- having an unexpected visitor or
telephone call.
Delayed recording:
Convenient when leaving the house or going to bed
R E C
REC
q
TIME increases the start time by 10 minutes.
REC.
STANDBY
(Ex.: Ending time: 9:30
lit). If this the
IS IS