Table of Contents
Advertisement
Solid-state drive
NOTE:
This section applies only to computer models equipped with an Intel processor.
Description
32-GB mSATA solid-state drive
Before removing the solid-state drive, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the battery (see
5.
Remove the service cover (see
Remove the solid-state drive:
1.
Remove the Phillips PM2.0×3.0 screw (1) that secures the solid-state drive to the system board.
(The solid-state drive tilts up.)
2.
Remove the solid-state drive (2) by pulling the drive away from the slot at an angle.
Battery on page
52).
Service cover on page
53).
Component replacement procedures
Spare part number
753909-001
59
Hide quick links:
Advertisement
Table of Contents
