Troubleshooting - Bike Friday tikit Manual

Trouble Shooting
Linear pull brake centering and spring adjustment
Linear pull brake arms are held off of the rim by a spring in each
arm. To center the brake (allowing both arms to retract an equal
amount), you need to adjust the respective spring tensions. At the
base of each Linear pull brake arm near the pivot is a small screw
pointing to the side. Turning this screw will change the centering
of the brake.
On the side which needs to retract farther, tighten this screw in half-
turn increments. You may also consider loosening the side which
retracts too far.
Headset adjustment:
The headset is the bearing in
which the fork turns. It is ad-
justed using the 5mm hex bolt
located underneath the stem
hinge. If the headset develops
play, simply tighten the bolt to
correct it. Do not overtighten.
tikit™
Cable
Uniquely, your hyperfold tikit™ uses one cable to give its
'magic' no fuss fold. The cable we use is strong and safe. If you
notice any damage to your tikit™ cable, such as fraying, then it
should be replaced immediately. Ideally this will be done by
your tikit™ Agent or a Bike Friday technician.
800-777-058 • +1-541-687-0487 www.bikefriday.com
1