Ready To Ride - Bike Friday tikit Manual

Note:
-Raising the seatmast un-
latches the rear end and
allows it to swing back
in place.
-As rear wheel rolls out
ensure the stem is correct
before wheel is fully in
place.
3. Latch
-Make sure rear wheel is
back in place Before
pushing seatmast into catch.
(if the frame latch at the rear
of the bike doesn't line up with
the seat mast perfectly, lift up a
bit on seat to allow cables to re-
set. Check that stem is correct).
Do NOT force seatmast down
if it is not aligned.
Tighten spin knob on the stem
hinge to secure the folding
stem.
4. Pedals
Unfold the pedals (if they
were folded).

Ready to ride!

800-777-058 • +1-541-687-0487
STEM CORRECT
Fix: Lift bike rear end to release cable
tension on stem, then push stem for-
ward as you lower rear end again.
www.bikefriday.com
STEM INCORRECT
11