Electric Lift; Removal; Installation - Toro 400XT Series Service Manual

Electric Lift

Removal

1. Remove the right and left hood stand panels to the
battery compartment.
2. Disconnect the negative and positive cables from
the battery.
3. Remove the two screws holding the battery
support and remove the support.
4. Unplug the actuator, 1, from the wiring harness.
5. Remove the clip pin, 4, and clevis pin, 6, that
holds the actuator, 1, to the actuator bracket
assembly, 7.
400XT Series Tractor Service Manual
(1) Actuator
(2) Spacer
(3) Clevis Pin
(4) Clip Pin
Figure 69
(5) Washer
(6) Clevis Pin
(7) Actuator Bracket Assembly
(8) Lift Arm Assembly
6. Remove the clip pin, 4, spacers, 2, washers, 5,
and clevis pin, 3, from the lift arm assembly, (8).
7. Remove the actuator, 1, from the tractor. The
actuator is serviced as an assembly; no repair
parts are available.
8. Remove the actuator

Installation

Reverse the order of removal.
CHASSIS
Eleclift
2 - 21