Table of Contents
Advertisement
3.
Hold the flats on the ball joint to align with the flats
on the tie rod and tighten the jam nut (Figure 9).
Figure 9
4.
Install the ball joint to the steering arm and check
the toe-in as described in the measurement
section (Figure 10).
Figure 10
Front Wheel and Spindle Removal
and Installation
Removal
1.
Disengage the PTO. Set the parking brake, and
turn the ignition key to OFF to stop the engine.
Remove the key.
2.
Raise the front axle by putting a jack under the
side you are removing the wheel or spindle from.
400XT Series Tractor Service Manual
3.
Remove the outer hub cap, cotter pin, washer,
and hub cap washer. Slide the wheel and tire off
the spindle (Figure 11).
MVC-098X
4.
Remove the tie rod from the front spindle arm.
With a drift punch and hammer, drive the roll pin
out of the front spindle arm (Figure 12).
MVC-099X
CHASSIS
Figure 11
Figure 12
MVC-100X
MVC-732X
2 - 3
Advertisement
Table of Contents
