Connections - Denon DRR-F101 Operating Instructions Manual

4

CONNECTIONS

Connecting to the D-F101 Series
When connecting to a receiver other than the one in the DRA-F101 there is no need to make connection 3. Note that
2
in this case none of the system functions (auto power on, etc.) will work.
• System operations such as the auto power on function
can only be used if stereo audio cords and system cords
are connected between all the system components. Be
sure to securely connect all the connection cords
between all the units.
• Disconnecting a system cord during system operation
may result in malfunction. Be sure to unplug the power
cords before changing the connections.
Plug into the open SYSTEM CONNECTOR jack of another
component. Any SYSTEM CONNECTOR jack is OK.
DRA-F101
(Receiver)
FM COAX. AM LOOP ANT. 1
2 SYSTEM R L
75 CONNECTOR
ANTENNA
+
INPUTS TAPE MD
L
PRE
OUT
-
AC OUTLET
230V 50Hz
SWITCHED
SPEAKER SYSTEM W MAX
R
SUB
SPEAKER IMPEDANCE 4~16
PHONO CD DVD/AUX PB REC PB REC WOOFER
• Install the components in such a way that the ventilation
holes of the receiver (DRA-F101) are not obstructed.
• Use the AC OUTLET for audio equipment only. Do
not use them for hair driers, etc.
4
DRR-F101
(Cassette deck)
3
DRR-F101
(this unit)
1
2
Connect the DRR-F101's LINE OUT jacks to the
1
receiver's TAPE input jacks using the included
stereo audio cord.
Connect the DRR-F101's LINE IN jacks to the
2
receiver's TAPE output jacks using the included
stereo audio cord.
Connect the DRR-F101's SYSTEM CONNECTOR
jack to the SYSTEM CONNECTOR jack (1 or 2) of
3
one of the other components using the included
system cord.
Connect this unit's power cord to the AC outlet
4
on the CD player (DCD-F101) or one of the other
components.
The DRR-F101 can also be used when connected to
a receiver other than the DRA-F101. In this case,
none of the system functions (auto power on, etc.)
will work.
Some receivers are equipped for connections of
two or more cassette deck's, allowing tapes to be
copied. Read your receiver's operating instructions
carefully before using it.
DMD-F101
1 3
POWER LOADING MECHANISM
ON / STANDBY INPUT MEMO REC / EDIT CD SRS MULTI REC
CHARACTER
18T r0 2 m 4 6 s
- +
1 L REC LEVEL
R dB -60 40 -30 -20 -12 -6 -2 0 / ENTER
MINIDISC RECORDER DMD-F101
DCD-F101
ON / STANDBY
REPEAT
TRACK
COMPACT DISC PLAYER DCD-F101
ENGLISH
Recommended System Installation
• To ensure performance and stability, install the D-F101
series as shown below.
• Do not place another component directly on top of the
receiver (DRA-F101).
• For stability, do not stack more than three components
on top of each other.
• To ensure stability, do not stack more than three units.
NOTES:
• Do not plug power cords into power outlets until all
connections have been completed.
• Check the left and right channels and be sure to
interconnect them correctly (R to R, L to L).
• Plug in the power cords securely. Incomplete
connections will result in noise.
• Clasping the power cords and connection cords
together may result in humming or noise.
• After unplugging the power cord, wait at least 5
seconds before plugging it back in.
DRA-F101
VOLUME
MEMORY TUNING SOURCE
FUNCTION TONE TIMER RDS / SET DOWN UP BAND DIRECT
SYSTEM
ON / STANDBY
PHONES
AM-FM STEREO RECEIVER DRA-F101
PLAY
DRR-F101
e
ON / STANDBY
CD SRS REC
DOLBY NR
ON CD SRS REC 0 PLAY 1
OFF REVERSE
MODE
CASSETTE DECK DRR-F101
5