5. Insert the wireless card connector into the system board connector until the card retention clasp catches the metal loop on the side of the chassis and

holds the card securely in place.

1 wireless card cable

3 Wi-Fi external antenna connector

5 wireless card connector

NOTICE:

When routing the wireless card cable through the chassis, avoid making sharp bends. This can cause signal degradation.

6. Route the wireless card cable through the cable channel on the top of the heatsink assembly, through the cable guides on the side of the hard drive

shroud, and to the back panel. Use cable clips with existing cable bundles to manage excess cable if necessary.

7. Remove the plug on the back panel where the connector for the Wi-FI antenna is installed.

8. Position the external antenna connector at the end of the wireless card cable in the antenna connector opening in the back panel so that the retaining

tabs on the connector faceplate pass through the opening, and the bent end of the connector faceplate is pointed away from the power supply.

9. Slide the connector sideways along the back panel slightly so that the retaining tabs on the connector faceplate hold the connector to the back panel.

10. Connect the Wi-Fi external antenna to the wireless card cable connector.

2 wireless card cable to antenna

4 card retention clasp release

Computer.

System Board

2 cable guides on hard drive shroud

4 wireless card assembly

Components).

Table of Contents