Dell OptiPlex 960 Service Manual page 119

1 drive release tab
6. Push down the drive release latch and slide the floppy drive towards the back of the computer. Then lift it out of the chassis.
7. If the drive is not being replaced with any device:
a. Disconnect the drive data cable from the connector on the system board, and remove it from the chassis.
b. Remove the bezel (see
c. Install an insert, if available, into the bezel to cover the drive bay.
d. Remove the shoulder screws from the drive and attach them to the inside of the bezel insert.
e. Replace the bezel (see
f. Perform the procedure
Installing a Floppy Drive
1. If you are installing a floppy drive into a bay that was previously unused:
Perform the procedure
l
Remove the bezel (see
l
Remove the floppy drive bay insert from the bezel (see
l
Remove the shoulder screws from the drive bay insert, and attach them to the floppy drive.
l
2. If you are installing a floppy drive different from the one removed, remove the three shoulder screws from the floppy drive removed and attach them to
the new floppy drive.
3. Align the screws on the drive with the bracket slots in the computer, and gently position the drive until it clicks into place.
2 floppy drive
Remove the Bezel).
Replacing the Bezel).
After Working on Your Computer.
Before Working on Your Computer.
Remove the Bezel).
Removing Drive Bay Inserts).