Dell OptiPlex 960 Service Manual page 73

1 2.5-inch hard drive caddy (flat
side up)
3 end of caddy with cable cutout
1 2.5-inch hard drive caddy (U-
shaped side up)
3 end of caddy with cable cutout
b. Secure the drive to the drive caddy with four screws, two on each side.
c. Connect a power cable y-adapter to the hard drive(s) installed in the caddy.
1 power cable adapter
d. Install the 2.5-inch hard drive caddy into the drive bay caddy with the U-shaped side toward the inside of the drive bay caddy. The pins inside the
drive bay caddy should align with the holes on the sides of the 2.5-inch hard drive caddy, with the cable cutouts of both caddies at the same end.
2 2.5-inch hard drive (primary drive
shown)
4 screws (4)
2 2.5-inch hard drive (secondary
drive shown)
4 screws (4)