Golden Technologies Buzzaround Lite Service Manual page 33

BEEP CODE #6 – THROTTLE TRIP (OUT OF NEUTRAL)
A throttle trip is indicated. Make sure the throttle is in the neutral position before switching on the scooter.
Remove the key from the key switch.
Make sure the throttle pot is not obstructed and it can return to the neutral (center) position.
Move the throttle pot forward and then reverse. Make sure that it is not obstructed.
Does it spring back to neutral the neutral position?
Insert the key into the key switch.
Does the code return?
Yes?
Go to BEEP CODE # 7
to test the throttle pot.
BEEP CODE #7 – THROTTLE TRIP/SPEED CONTROL FAULT (VOLTAGE ERROR).
A throttle trip is indicated. This fault indicates a problem with the throttle control or speed control.
Insert the positive lead (red) from the multimeter into the back of pin 6 (yellow wire) on the main harness (MH2).
Connect the negative lead (black) from the multimeter to BAT-. Use the BAT- terminal that is connected to ICH2.
Measure the voltage.
Disconnect the throttle pot from the top dashboard.
Check the top dashboard.
Is it discolored or damaged?
Yes?
Replace the top dashboard.
Reseat the pins,
reconnect the throttle pot
to the top dashboard, and
try to run the scooter.
Yes?
OK
Make sure the batteries are fully charged.
Remove the battery pack.
Remove the battery pack lid.
Reinstall the battery pack onto the scooter frame.
Open the front control panel.
Insert the key into the key switch.
Out of range?
No?
No?
Are the pins on the connectors seated correctly?
Check for obstruction.
Replace if there are no obstructions.
No?
Measure resistance across pin 2
(yellow wire) and pin 3 (orange wire)
on the throttle pot connector.
Approximately
2.7k ohms?
Replace the top dashboard.
Buzzaround_SG_REVA_040711
No?
Approximately 25VDC?
Out of range?
Replace the throttle pot.
Yes?
32