Batteries - Golden Technologies Buzzaround Lite Service Manual

BATTERIES

To replace the batteries:
1) Place the freewheel lever in the engaged position.
2) Remove the key from the key switch.
3) Remove the seat.
4) Remove the battery pack.
5) Remove the twelve screws holding the top and bottom halves of the battery pack together. See figure 9.
6) Disconnect the charger harness from the intermediate charger harness. See figure 10 on page 22.
7) Remove the B+ and B- wires from each battery.
The circuit breaker is wired between the B+ of one battery and the B- of the opposite battery.
Make sure the polarities are correct when connecting the batteries.
8) Remove the batteries.
9) Remove the hook and loop fasteners from the bottom of each battery.
10) Place the hook and loop fasteners on the bottom of the two new batteries.
11) Place the two new batteries into the battery pack.
Note: The batteries must be placed into the battery pack with the terminals facing rearward. See figure 9.
BATTERIES (Qty. 2)
PHILLIPS HEAD SCREWS
(Qty. 12)
12) Reconnect the B+ and B- wires to each battery.
Prevent electrical shock and damage to the batteries or scooter. Make sure the polarities are
correct before connecting the two new batteries. See figure 10 on page 22.
21
TOP HALF
Figure 9. Battery Pack
BATTERY TERMINALS
BOTTOM HALF
Buzzaround_SG_REVA_040711