1
2
3
1
optical drive
3
cable connector
7 Slide the drive at an angle toward the side of the computer.
8 Remove the cable connector from the back of the drive.
9 Lift the drive out of the computer base.
Replacing the Optical Drive
1 Connect the cable connector to the back of the drive.
2 Place the drive back in position and replace the two M2 x 3-mm screws
that secure the optical drive to the computer base.
3 Replace the palm rest (see "Replacing the Palm Rest" on page 79).
4 Replace the display assembly (see "Replacing the Display Assembly" on
page 67).
5 Replace the keyboard (see "Replacing the Keyboard" on page 56).
6 Replace the hinge covers and center control cover (see "Replacing the
Hinge Covers and Center Control Cover" on page 47).
84
Optical Drive
2
M2 x 3-mm screw (2)