Stick Start Procedure − Scratch Start Technique - Miller TRAILBLAZER 275 DC Owner's Manual

Switch Setting
Electrode Hot − Wire
Electrode Hot − Stick
Electrode Hot − Stick
Electrode Hot − Lift Arc w/Auto-Crater
Electrode Hot − Lift Arc w/Auto-Stop
TIG − Remote On/Off
Stick − Remote On/Off
Wire − Wire Feeder (CV) Using
Remote
6-5. Stick Start Procedure − Scratch Start Technique
Table 6-1. Process/Contactor Switch Settings
Process
MIG (GMAW)
Stick (SMAW)
Select Preferred Dig
Air Carbon Arc (CAC-A) Cutting And Gouging
Select Any Dig
TIG (GTAW) Lift Arc w/Auto-Crater (GTAW) (DC Only)
TIG (GTAW) Lift Arc w/Auto-Stop (GTAW) (DC Only)
TIG (GTAW) With HF Unit, Pulsing Device, Or
Remote Control (AC or DC)
Stick (SMAW) With Remote On/Off
MIG (GMAW)
1
3
.
A complete Parts List is available at www.MillerWelds.com
With Stick selected, start arc as
follows:
1
2
3
Drag electrode across workpiece like
striking a match; lift electrode slightly
after touching work. If arc goes out
electrode was lifted to high. If
electrode sticks to workpiece, use a
2
quick twist to free it.
Output On/Off Control
Electrode Hot
Electrode Hot
Electrode Hot
Electrode Hot
Electrode Hot
At Remote Receptacle
At Remote Receptacle
At Remote Receptacle
Electrode
Workpiece
Arc
OM-4426 Page 33