Showroom Mode; Sabbath Mode - Viking FDBB5361 Service Manual

Showroom Mode

Showroom mode allows electronic controls and
interior lights to function independently of the
refrigeration system.
To enter Showroom mode:
Press and hold the "ACTIVATE
CONTROLS" pad. While
holding, press and hold the
"HIGHER" and "ALARM OFF"
pad simultaneously. Continue
holding until three beeps
are heard and then "SHOW"
is illuminated along with
Refrigerator and 38
0 F. Whichever section was active prior
O
to to showroom mode being entered will
determine which one is displayed.
To exit Showroom mode: Press and hold the
"ACTIVATE CONTROLS" pad. While holding,
press and hold the "HIGHER" and "ALARM
OFF" pad simultaneously. Continue holding
until three beeps are heard. The display will
revert to normal operation

Sabbath Mode

To enter Sabbath mode, press and
hold "ACTIVATE CONTROLS" pad
then press and hold "DISPLAY
OFF" pad, together for three
seconds this will cause an audible
three beeps, signifying that
Sabbath mode has been entered.
©2012 Viking Preferred Service
ACTIVATE
CONTROLS
HIGHER
ALARM
OFF
F or Freezer and
O
HIGHER
ACTIVATE
CONTROLS
DISPLAY
OFF
When Sabbath mode has been entered the
display illuminates "SAB", see illustration
below. "SAB" will remain illuminated whether
the door(s) are open or closed, it will not
change state. Indicators that were illuminated
on the display prior to going into Sabbath
mode will remain illuminated and unchanged
until exiting Sabbath mode.
Sabbath mode is used to control the
refrigerator without interior lights, LED
display changes and enunciators. Alarms are
suppressed, you will not get visual or audible
alarms during Sabbath mode, although they
are recorded in memory and will be displayed
upon exiting Sabbath mode.
The freezer/refrigerator outputs (compressor,
fans,etc.) should not have an immediate
reaction from a user action. If the control calls
for an action because the door was opened
or closed, the control shall delay its reaction
randomly (15-25 seconds).
To exit "SABBATH" mode, press and hold
"ACTIVATE CONTROLS" and then "DISPLAY
OFF" together for three seconds, an audible
three beeps will be heard and "SAB" on
display will extinguish. The display will return
to normal and any alarms will be visually and
audibly displayed.
Operation
9