Program Mode C; Set Model Type; Adjust Freezer Upper Temperature Limit; Adjust Freezer Lower Temperature Limit - Viking FDBB5361 Service Manual

Program Mode C

If you are not already in Mode B, go back to
Mode B instructions on Page 33.
Once you are in Mode B (Prb in display),
press and hold "ALARM OFF" for
three seconds and display will
change to "PrC", signifying that
control is now in Program Mode
C, see illustration below.

Set Model type

While in Mode C, press and
release, either "FRZ TEMP or
REF TEMP" to display the current
model type setting, a three digit
number in the display.
Pressing and releasing either
"HIGHER or LOWER" pads will
allow you to change model types
until you get to the proper three
digit number for your unit, see
Table 1 on Page 42 . The correct
type number for this unit is 136.
The "REFRIGERATOR and/or FREEZER"
indicators will illuminate for each model type
as it is selected depending upon the model
configuration. (example: code 430 will only
illuminate the "REFRIGERATOR" indicator
because it is an All Refrigerator)
©2012 Viking Preferred Service
Setting the model code is required
whenever the low voltage board is
replaced, this will update all of the settings
indicated in Table 1 on Page 42 for the
model you select. With this setting you can
program all necessary settings with one
input for the appliance.
ALARM
OFF

Adjust Freezer Upper Temperature Limit

While in Mode C, press and hold
"MAX FRZ" and and then hold the
"HIGHER" pad for three seconds,
this will result in the display
changing to "FUL".
FRZ
TEMP
REF
TEMP
Pressing and releasing "HIGHER
and LOWER" pads will increase
or decrease the set point, which
HIGHER
should be set at 7
LOWER

Adjust Freezer Lower Temperature Limit

While in Mode C, press and hold
"MAX FRZ" and and then hold the
"LOWER" pad for three seconds,
this will result in the display
changing to "FLL".
Service Procedures
F.
o
MAX
FRZ
HIGHER
HIGHER
LOWER
MAX
FRZ
LOWER
37