Defrost Start Delay; Defrost Termination Delay; Constant Evaporator Fan Mode; Plant Mode - Viking FDBB5361 Service Manual

Defrost start delay

This adjustment is not a field adjustment and
should not be performed by technicians. This
is a factory only adjustment.
If you see "dSd" in the display, immediately
exit Mode C by holding "ACTIVATE
CONTROLS" for three seconds until you get
three audible beeps. Return to your previous
actions.

Defrost termination delay

This adjustment is not a field adjustment and
should not be performed by technicians. This
is a factory only adjustment.
If you see "dtd" in the display, immediately
exit Mode C by holding "ACTIVATE
CONTROLS" for three seconds until you get
three audible beeps. Return to your previous
actions.

Constant Evaporator fan mode

This mode only applies to All Refrigerator
units and is ignored by any other unit
configuration.

Plant mode

This adjustment is not a field adjustment and
should not be performed by technicians. This
is a factory only adjustment.
If you see "Pt" in the display, immediately turn
power switch to OFF. Turn power back on and
start over.
©2012 Viking Preferred Service
Service Procedures

Exiting Mode C

To exit Mode C and retain any changes
made in system up to this point you
must press and release
"ACTIVATE CONTROLS" one
time, the display changes to
"Prb". This signifies that the
changes were written to the eeprom
and that the system has left Mode C
and returned to Mode B.
The other way to ensure changes
have been written into the eeprom
is to press and hold "ACTIVATE
CONTROLS" for three seconds and
you will get three audible tones along
with a normal temperature display.
This indicates that you have left Mode
C and returned to normal operation.
Failure to do this will cause system
to time out after 10 minutes and any
changes will be lost.
ACTIVATE
CONTROLS
39