Kenwood DDX9016S Instruction Manual page 70

CONNECTION/INSTALLATION
Connection
❏ Connecting wires to terminals (for DDX9016S/DDX9016SM/DDX9016DABS)
VIDEO OUT
Page 74
REAR VIEW CAMERA
FRONT VIEW CAMERA
Pages 72 – 74
Page 74
Page 74*
Connect the antenna cord
to the antenna terminal.
White
To front speaker (left)
White with black stripe
Gray
To front speaker (right)
Gray with black stripe
To rear speaker (left)
Green
Green with black stripe
To rear speaker (right) Purple
Purple with black stripe
Ignition key switch
(ACC)
(BATT)
Fuse box
To car chassis
(GND)
Battery
70
Connect GPS antenna (6). (Page 75)
Page 75 Page 74
AV-IN
1
Light blue with yellow stripe
(Steering remote control wire)
Blue (Antenna control wire)
Blue with white stripe (Power
control wire)
Orange with white stripe (Dimmer
control wire)
Purple with white stripe (Reverse
sensor wire)
Red (Ignition wire)
Light green (Parking sensor wire)
Yellow (Battery wire)
Black (Ground wire)
If no connections are made, do not let
the cable come out from the tab.
* Only for DDX9016DABS.
Connect the USB extension cable (5). (Page 72)
Connect a navigation box. (Page 74)
Connect to the vehicle's steering remote harness using the Steering remote cable
(8). (Page 74)
• Contact your Kenwood dealer for details.
15 A fuse
To use the steering wheel remote control feature, an
REMOTE CONT
exclusive remote adapter (not supplied) matching your
STEERING WHEEL
car is required.
REMOTE INPUT
Depending on what antenna you are using, connect
either to the control terminal of the motor antenna, or to
the power terminal for the booster amplifier of the film-
ANT CONT
type antenna. (Max. 300 mA, 12 V)
When using the optional power amplifier, connect to its
power control terminal.
P.CONT
To car light control switch
ILLUMI
Connect to the vehicle's reverse lamp harness when
REVERSE
using the optional rear view camera.
PRK SW
Connect to the vehicle's parking brake
detection switch harness.
• For best safety, be sure to connect the
parking sensor.