Yamaha GRIZZLY 125 YFM125GA Owner's Manual page 91

fore cleaning the spark arrester.
1. Remove the screws and their gasket.
1. Screw
2. Remove the tailpipe by pulling it out of the
muffler.
3. Tap the tailpipe lightly, and then use a wire
brush to remove any carbon deposits from the
spark arrester portion of the tailpipe and inside
of the tailpipe housing.
1
1. Screw
2. Gasket
3. Tailpipe
4. Spark arrester
4. Insert the tailpipe into the muffler and align the
screw holes.
5. Check the gaskets for damage, and replace
them if necessary.
6. Install the screws and their gasket, and then
tighten the screws to the specified torque.
Tightening torque:
Tailpipe screw:
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
8-22
3
4
1
2
1
2
3
4
5
6
7
8
9
10
11