Yamaha SR400 Owner's Manual page 49

Periodic maintenance and adjustment
1 2
1. Engine oil drain bolt (oil tank)
2. Gasket
TIP
Skip steps 6–8 if the oil filter element is
not being replaced.
6. Remove the oil filter element cover
by removing the bolts.
1. Oil filter element cover bolt
7. Remove and replace the oil filter
element and O-rings.
TIP
Make sure that the O-rings are properly
seated.
1
1. Oil filter element cover
2. O-ring
3. Oil filter element
8. Install the oil filter element cover by
installing the bolts, and then tight-
en the bolts to the specified torque.
Tightening torque:
Oil filter element cover bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
1
9. Install the oil filter element drain
bolt, and then tighten the bolt to the
specified torque.
Tightening torque:
Oil filter element drain bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
10. Install the oil filter element cover
bleed bolt and its gasket, and then
tighten the bolt to the specified
torque.
Tightening torque:
Oil filter element cover bleed bolt:
5 Nm (0.5 m·kgf, 3.6 ft·lbf)
11. Install the engine oil drain bolts
and their new gasket, and then
tighten the bolts to the specified
torques.
6-11
3
1
2
2
3
4
5
6
7
8
9
10
11
12
13
14