Handlebar Switches; Throttle Lever - Yamaha BANSHEE YFZ350 Owner's Manual

EBU18061

Handlebar switches

1
2
3
4
5
6
7
1. Light switch "LIGHTS"
2. Engine stop switch "ENG. STOP"
8
EBU18070
Engine stop switch "ENG. STOP"
9
Set this switch to "RUN" before starting the engine.
10
The engine stop switch controls the ignition and
stops the engine when it is running. Use this switch
11
to stop the engine in an emergency situation. The
engine will not start or run when this switch is set
to "OFF".
1
2
EBU18140
Light switch "LIGHTS"
Set this switch to "LO" to turn on the low beams
and the taillight. Set the switch to "HI" to turn on the
high beams and the taillight. Set the switch to
"OFF" to turn off all the lights.
ECB00040
CAUTION:
Do not use the headlights with the engine
turned off for an extended period of time, oth-
erwise the battery may discharge to the point
that the starter motor will not operate properly.
If this should happen, remove the battery and
recharge it.
EBU18280

Throttle lever

Once the engine is running, movement of the throt-
tle lever will increase the engine speed.
Regulate the speed of the ATV by varying the
throttle position. Because the throttle is spring-
loaded, the ATV will decelerate, and the engine will
return to an idle any time the hand is removed from
the throttle lever.
4-2