Specifications - Makita 9403 Instruction Manual

ENGLISH (Original instructions)
1-1. Lock button
1-2. Switch trigger
2-1. Lever
4-1. Adjusting knob
5-1. Dust bag

SPECIFICATIONS

• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for the sanding of large surface of
wood, plastic and metal materials as well as painted
surfaces.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
For European countries only
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Vibration
The vibration total
determined according to EN60745:
Work mode : sanding metal plate
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
Explanation of general view
5-2. Dust spout
6-1. Fastener
7-1. Steel plate
7-2. Carbon plate
7-3. Strap washer
Model
Belt size
Belt speed
Overall length
Net weight
Safety class
) : 86 dB(A)
pA
) : 97 dB(A)
WA
value (tri-axial vector
2
) : 2.5 m/s or less
h
2
ENE052-1
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
ENF002-1
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
ENG102-2
EC Declaration of Conformity
We Makita
manufacturer declare that the following Makita
machine(s):
Designation of Machine: Belt Sander
Model No./ Type: 9403
are of series production and
Conforms to the following European Directives:
ENG212-2
98/37/EC until 28th December 2009 and then with
2006/42/EC from 29th December 2009
sum)
And are manufactured in accordance with the following
standards or standardised documents:
EN60745
The technical documentation is kept by our authorised
representative in Europe who is:
ENG901-1
Makita International Europe Ltd,
Michigan, Drive, Tongwell,
Milton Keynes, MK15 8JD, England
000230
3
8-1. Limit mark
9-1. Screwdriver
9-2. Brush holder cap
9403
100 mm x 610 mm
500 m/min.
353 mm
5.7 kg
/II
Corporation as the
30th January 2009
ENH101-12
responsible