Specifications - Makita DBO484Z Instruction Manual

ENGLISH (Original instructions)

SPECIFICATIONS

Model:
Pad size
Abrasive paper
Orbits per minute
Overall length (with BL1860B)
Rated voltage
Net weight
* The standard pad differs from country to country.
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications and battery cartridge may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-
est combinations, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of
residence.
WARNING:
Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.
Intended use
The tool is intended for the sanding of large surface of
wood, plastic and metal materials as well as painted
surfaces.
Noise
The typical A-weighted noise level determined accord-
ing to EN62841-2-4:
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB (A).
NOTE: The declared noise emission value(s) has
been measured in accordance with a standard test
method and may be used for comparing one tool with
another.
NOTE: The declared noise emission value(s)
may also be used in a preliminary assessment of
exposure.
Square pad
Triangular pad
Rectangular pad
For square pad (Hook and loop)
For square pad (Clamp)
For triangular pad
For rectangular pad
High
Low
) : 78 dB(A)
pA
112 mm x 168.5 mm
Rectangular paper: 114 mm x 102 mm
Triangular paper: 96 mm
112 mm x 168.5 mm, 112 mm x 66 mm
BL1815N / BL1820B / BL1830B / BL1840B / BL1850B / BL1860B
DC18RC / DC18RD / DC18RE / DC18SD / DC18SE / DC18SF /
DC18SH / DC18WC
WARNING:
Wear ear protection.
WARNING:
The noise emission during actual
use of the power tool can differ from the declared
value(s) depending on the ways in which the
tool is used especially what kind of workpiece is
processed.
WARNING:
Be sure to identify safety mea-
sures to protect the operator that are based on an
estimation of exposure in the actual conditions of
use (taking account of all parts of the operating
cycle such as the times when the tool is switched
off and when it is running idle in addition to the
trigger time).
Vibration
The vibration total value (tri-axial vector sum) deter-
mined according to EN62841-2-4:
Work mode: sanding metal plate (square base)
Vibration emission (a
Uncertainty (K) : 1.5 m/s
7 ENGLISH
DBO484
112 mm x 102 mm
112 mm x 190 mm
114 mm x 102 mm
114 mm x 140 mm
-1
14,000 min
-1
11,000 min
171 mm
D.C. 18 V
1.4 - 1.8 kg
2
) : 2.5 m/s or less
h
2