Conserving Battery Life; Headset Tones; Battery Life Status; Headset Indicator Light - Plantronics Savi W440 User Manual

Conserving battery life

Turn the headset battery off when not in use.

Headset tones

Out of range warning
If you are on a call and go out of the operating range, you will
hear three low tones. You will hear a single mid tone when you are
back in range.
If you stay out of range, active calls will be suspended. Calls will
be re-established when you walk back into range. If you remain
out of range for more than 5 minutes, the system will drop the
call.
If you are not on a call and go out of the operating range and
press the call control button, you will hear a single tone for the
button press and three low tones for the failure to make a link.
Low battery warning
If you are on a call, you will hear a repeated single low tone every
15 seconds indicating that the battery is low. You should recharge
the headset immediately.
If you are not on a call and press the call control button, you will
hear three low tones indicating that the battery is low. You should
recharge the headset immediately.

Battery life status

AAt the lower right corner of your screen in your system tray, your
headset battery status will be indicated with one of the following
icons:
NOTE Plantronics Hub Software must be installed for system tray
icon. (See next section)
100% 75% 50%
A warning will be issued if your headset is critically low.

Headset indicator light

If you are not on a call, you can toggle the headset in-use
indicator light on and off by pressing the headset volume down
button (press volume up for left ear configuration) for three
seconds.
Plantronics Savi User Guide
0%

Subscribing a headset

The headset and USB adapter that are supplied together are
already subscribed to each other. However, if you wish to use
a new headset with your existing USB adapter or you need to
restore subscription to your current headset, the units can be
subscribed to each other by the following method:
1 Ensure your headset is charged.
2
Double press the subscription button on the USB
adapter. The USB adapter will flash red and green.
3 Press the volume up button (press volume down for left
ear configuration) on the headset for three seconds until
the headset indicator light turns solid white.
4 When the indicator light on the USB adapter goes solid
green, the headset and the USB adapter are subscribed
to one another.
To
ensure subscription was successful, press the call control
button: the headset will flash white and the USB adapter will
flash green.
NOTE If the subscription process times out after two minutes or if
the subscription process fails, the USB adapter indicator light will
become solid red for four seconds and then return to its previous
state. If this occurs, try to re-subscribe the headset again.

Ending subscription

If the USB adapter is in subscription mode and you want to stop
the adapter from searching for a headset, press the subscription
button again. The subscription light will turn solid red for four
seconds and then go to its previous state.
Listening to other PC audio
Ensure the PC audio that you are trying to listen to is being routed
to your Savi 400 device.
1
Go to "Windows" and open "Sound".
2 Select your Savi 400 device under "Sound Playback".
3 Launch the application that contains the PC audio and
hit play.
11