IKEA LAGAN User Manual page 12

ENGLISH
Problem
Water flows on the rear
plate of the refrigera-
tor.
Water flows into the re-
frigerator.
Water flows on the
ground.
The temperature in the
appliance is too low/
high.
If your appliance is still not working proper-
ly after making the above checks, contact
the After Sales Centre. You can find the list
at the end of this manual.
Replacing the lamp
Caution! Disconnect the plug from the
mains socket.
1. Remove the
screw from
the lamp
cover.
2. Remove the
lamp cover.
3. Replace the
lamp with
one of the
same power
and specifically designed for household
appliances. (the maximum power is
shown on the lamp cover).
Possible cause
The room temperature is too
high.
During the automatic defrost-
ing process, frost defrosts on
the rear plate.
The water outlet is clogged.
Products prevent that water
flows into the water collector.
The melting water outlet does
not flow in the evaporative
tray above the compressor.
The temperature regulator is
not set correctly.
Solution
Decrease the room tempera-
ture.
This is correct.
Clean the water outlet.
Make sure that products do
not touch the rear plate.
Attach the melting water outlet
to the evaporative tray.
Set a higher/lower tempera-
ture.
4. Install the lamp cover.
5. Tighten the screw to the lamp cover.
6. Connect the plug to the mains socket.
7. Open the door. Make sure that the light
comes on.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
the assembly instructions.
3. If necessary, replace the defective door
gaskets. Contact the After Sales Service.
12