Shelf Supports; Removing The Shelf Supports; Installing The Shelf Supports - AEG BP3003021 User Manual

20 www.aeg.com
Stainless steel or aluminium ap-
pliances:
Clean the oven door with a wet
sponge only. Dry it with a soft
cloth.
Do not use steel wool, acids or
abrasive materials, as they can
cause damage to the oven sur-
face. Clean the oven control pan-
el with the same precautions.

Removing the shelf supports

Installing the shelf supports

Install the shelf supports in the opposite
sequence.
The rounded ends of the shelf
supports must point to the front.
10.2 Pyrolysis
WARNING!
The appliance becomes very hot.
There is a risk of burns.
CAUTION!
If a hob is installed with the ap-
pliance, do not use it at the same
times as the Pyrolysis function. It
can cause damage to the appli-
ance.
2
1

10.1 Shelf supports

You can remove the shelf supports to
clean the side walls.
1. Pull the front of the shelf support
away from the side wall.
Pull the rear end of the shelf sup-
2.
port away from the side wall and re-
move it.
1. Remove the removable shelf sup-
ports (if applicable) and accessories
from the appliance. Refer to "Re-
moving the shelf supports".
CAUTION!
Do not let the removable shelf
supports stay in the appliance
during the cleaning procedure.
There is a risk of damage.
2. Remove the worst dirt manually.
3. Fully close the oven door.
The cleaning procedure cannot
start if you do not close the oven
door.
4. Set the function Pyrolysis. Refer to
"Oven functions".
5.
When flashes, press + or - to set
the necessary procedure: