Makita UH200D Technical Information page 8

W
iring diagram (cont.)
Fig. D-3
Wind Controller´s Lead wires (blue, white)
one time around Line filter.
To Plus pole of DC Motor
To Minus pole
of DC Motor
Fig. D-5
Connect Receptacles to the Switch with facing the wire
connecting portion to the Housing set (L) side in order
to put the Lead wires on the Housing set (L).
from Plus pole
of Terminal
Switch
Fig. D-6
Fix Controller´s Lead wires
(red, black) in this Lead
wire holder.
Terminal
Fig. D-4
Controller has to be put into Housing set (L).
Note: Bring the Lead wire (blue) connecting portion to the bottom
Line filter
Controller
from Controller
Housing set
(L) side
LED circuit
Pass the Lead wires of
LED circuit between
the Ribs.
Switch
side (Helical gear 47 side) and the wires connecting portions
to the front side (protector side).
DC Motor
Bottom side (Helical gear 47 side)
Connect Receptacles to the Terminal with facing
the wire connecting portion to Housing set (L) side.
Terminal
Adhesive
DC motor
Controller
P 8/ 8
Front side
(Protector side)
Lead wire (blue)
Housing set (L)
Housing set
(L) side
In case Line filter has to
be used, put Line filter
into the space designated
with gray color.
Controller
Fix all of the Lead wires
of Controller in this
Lead wire holder.