Makita UH200D Technical Information page 6

R
epair
[2] DISASSEMBLY/ASSEMBLY
[2]-3. Shear blade assembly
DISASSEMBLING
(1) Pull the rear portion of Base frame toward rear side designated with arrow. (Top left in Fig. 2)
(2) With pressing Lock lever, turn under cover complete to the unlocked position. (Top right in Fig. 2)
(3) Disassemble Under cover, and then remove Shear blade assembly. (Center left in Fig. 2)
ASSEMBLING
(1) Mount Shear blade assembly. (Fig. 10)
Fig. 10
1. Adjust Crank complete to
the position as drawn below.
Crank complete
Joint of Housing set (L)
and Housing set (R)
4. Tighten M4 Countersunk head screws.
Shear blade
assembly
(2) Mount Under cover complete. (Fig. 11)
Fig. 11
5. Put Under cover complete on the bottom of
Housing set as drawn below.
Unlocked position
Under cover
complete
2. Align the Holes of Shear blade A and B
to the Hole of Guide plate in order to set
M4 Pan head screw as a positioning pin.
M4 Pan head
screw
Guide plate
Shear blade A
M4 Countersunk
head screw
6. With pressing Lock lever, turn Under cover complete
Lock lever
3. Mount Shear blade assembly
with fitting the loops of Shear
blades A and B into Crank
complete
Shear blade B
toward the locking position as drawn below.
P 6/ 8
Locking position