Replacing Fuse - Yamaha F225F Owner's Manual

Trouble Recovery
cy, be sure to keep the unused one tilted up
and operate the other engine at low speed.
ECM00371
NOTICE
If the boat is operated with one engine in
the water but not running, water may run
into the exhaust pipe due to wave action,
causing engine trouble.
TIP:
When you are maneuvering at low speed,
such as near a dock, it is recommended that
both engines be running with one in neutral
gear if possible.
EMU41882

Replacing fuse

EWM00632
WARNING
Substituting an incorrect fuse or a piece
of wire could allow excessive current
flow. This could cause electric system
damage and a fire hazard.
If a fuse has blown, replace the fuse accord-
ing to the following procedure.
1. Turn the main switch to the "
position.
2. Remove the fuse box cover.
3. When replacing the main fuse or isolater
fuse, remove the screws, and then re-
move the fuse. Install the spare fuse,
and then tighten the screws.
95
1
11
2 3
4 5
1. Fuse box cover
2. Main fuse (100 A)
3. Isolator fuse (100 A)
4. Fuel feed pump fuse (10 A)
5. Main switch / PTT switch / Digital electronic
control ECM (Electronic control module) fuse
(20 A)
6. Shift actuator fuse (15 A)
7. Starting switch (30 A)
8. Ignition coil / Fuel injector / Variable cam-
shaft timing / Engine ECM (Electronic control
module) fuse (30 A)
9. Electric throttle valve fuse (10 A)
10. Fuel pump fuse (15 A)
11. Screw
3
" (off)
1. Spare fuse (100 A)
2. Spare fuse (10 A, 15 A, 20 A, 30 A)
3. Fuse puller
4. When replacing a fuse other than the
main fuse or isolater fuse, remove the
6 7 8 9 10
1 2
2
ZMU07195
ZMU06961