wind direction.
EMU27822
Stopping engine
Before stopping the engine, first let it cool off
for a few minutes at idle or low speed. Stop-
ping the engine immediately after operating
at high speed is not recommended.
EMU27848
Procedure
1.
Push and hold the engine stop button or
turn the main switch to "
2.
After stopping the engine, disconnect
the fuel line if there is a fuel joint on the
outboard motor.
" (off).
3.
ZMU02083
4.
TIP:
The engine can also be stopped by pulling
the cord and removing the clip from the en-
gine shut-off switch, then turning the main
switch to "
EMU27865
EWM00741
Excessive trim for the operating condi-
tions (either trim up or trim down) can
cause boat instability and can make
steering the boat more difficult. This in-
creases the possibility of an accident. If
the boat begins to feel unstable or is hard
to steer, slow down and/or readjust the
Tighten the air vent screw on the fuel
tank cap (if equipped).
Remove the key if the boat will be left un-
attended.
" (off).
Trimming outboard motor
WARNING
Operation
ZMU05547
ZMU02041
46